Looking to get some help tightening timings, I have a very strong IMC on my chip (14900KS (MC 95)), but my board (Apex Encore) is at it's limits of stability with anything over 8400 with two sticks.
It will not pass TM5 DDR5, Karhu or Y-Cruncher past 8400 no matter the timings or voltages thrown at it, so I got it stable at this XMP tweaked settings, with a CAS latency of 34 and maxed out trefi (water cooled) below.
So any help on tightening some timings on this M-Die kit would be greatly appreciated.
They are T-force Extreme DDR5 8400 sticks idlf that matters.
2 Comments
O hello, could you provide default XMP timings? Or are those timings default you posted here?
M-dies are really hard to tighten exspecially at those high MT/s.
– tRP/tRCD might go to 51 or lower, especially at your voltage
– tRCDWR can easily do 20
– tWRPRE might be able to go to 48
– tRDWR_dg and sg can probably go to 20
– tWRRD_dg can probably do 44/46
– tWCL has some room to mid 20s (will affect tWRPRE if tWR set)