Tag

Over Clocking

Browsing
what else can i change?

i tried tRFC 540 and tWR 18 but got worse latency (~70ns compared to 67ns with the timings in the pic) and became unstable also tried 3800mt/s but i think my cpu didnt like it hynix cjr 4x8gb @ 1.4v…

Timings hynix 3600 or 3800

Timings hynix 3600 or 3800 Help me make timings for RAM g skill ripjaws5 2x16gb, get along in timings or make 3800 frequency? Motherboard gigabyte b450s2h, processor ryzen 5 5600, soc 1.06, vdim 1.36, vddp 0.9, vddg ccd 0.9, vddg…

Something is wrong with my timings.

Some of my timings are set incorrectly, as the best result I've ever achieved with pyprime is 6.650. Could you please help me figure out where I made a mistake? These settings don't cause errors in the Y-Cruncher VT3 for…

Need help for airflow !

Need some advice on my airflow setup. I want to keep 3 fans at the bottom. My case officially supports only 1 bottom intake, so 1 fan is properly mounted and the other 2 are zip-tied under the GPU. All…

Is it Stable ?

I know not enough to know need to continue on test for a while but can we just say I can keep below settings @ 52250 mhz? CO : -30 PBO : Disabled (I perefer low temps like 60 degreees)

I9 14900k Cinebench R26

Specs: Z790 Tomahawk wifi Ddr5 7200mhz cl34 corsair I9 14900k What do you think about this score? It was achieved by these settings: Extreme profile PL1:300w PL2:320 Lite load mode 11 with a -0.030 undervolt Ratio per core 57x Turbo…