Comments and suggestions are welcome. Thank you.

https://www.pny.com/xlr8-ddr4-2666mhz-desktop-memory I have this kit I got at Best Buy ages ago and was screwing around with it, managed to get it to boot into Windows at 3600 MT/s with ~20-22-22 timings at 1.2v and I thought it was funny.…

Is it possible to achieve higher read and write speeds and lower latency (less than 60n/s)? What other timings can be adjusted?

i get consistently around 60ns with the same basic tune compared to a few months ago where i had around 63-65ns Hynix A/M-die (not sure) 16gbit dual rank but only 1 stick so single channel

When it will die? RX470

+3000 mem | +370 core. Second picture is the highest score with stock bios, +3000 mem | +400 core. max power, max core mv.

I literaly upgraded my (ADATA XPG lancer blade 6000mhz) ram kit from being obviously 6000 mhz to 6400 and with 30cl timings, the point is that ADATA also sells the same ram kit but oc to 6400mhz and 32cl but…

For the Testmem5 config I raised voltages to be 100% that if I error it would be a timing issue and not a voltage issue. I will minimise voltages but for now not a problem I have good cooling. Please…

Hi Guys, i'm completely happy with my CPU, even view Years later. It is manually overclocked to the Values that Asus AI OC would provide autmatically. Everything runs fine. But the Ring Cache on Alder Lake is fluctuating by Design.…

I have a cooling fan on my sticks well, so with no actual load, they sit at 37.5C at around 80C room temp. My room gets extremely hot over the summer, so that's why I have the cooling fan

4×8 32 gb hynix chip

My teamgroup 32gb ddr5 6000mhz cl30 kit is defective, one stick cant run 6000mhz without errors in TM5/memtest86. If i get these gskills ill RMA my teamgroup and sell it to offset the cost of the gskill canada computers had…