good for daily use ?
I managed to get the cores to 5ghz and uncore to 4.8ghz after delidding and replacing the TIM under the IHS with TG Conductonaut Extreme, max temps i’ve seen in heavy all core OCCT load and sustained is 56-57C. I’m…
I think these are M chips, although some of my readings make me think I might be wrong. The label says 1.4V (Kingston Fury 6000MHz CL30 RGB). In any case, everything seems stable when running various tests with OCCT (2…
Hello!! can anyone check if this is all good? Can I do something more? these are gskill tridents 6000hz cl26 kits tweaked from their default XMP. Would you recommend trying 8000+ with higher clas? would it bring down the latency…
I set significantly lower frequencies for ccd1 on my ryzen 9900X to accommodate for the lower undervolt which is -45 all the way to -55 depending on the cores frequency. On ccd0 I have -25 all core with no stretching.…
Hi, can you help me? What can I change to stop the memory from overheating? I should mention that I have a SFF case, there's no way to install fans, and I don't game on my computer, just work. I…
I have a ryzen 9 7950x3d that i have an undervolt on. in the past i’ve been stable with -30 on CCD0 and -35 on CCD1 but that was with an old/kinda broken air where i would idle around 60-70C…
I tried my best having no knowledge to ram overclocking. I watched a bunch of YouTube tutorials and bit help from ChatGPT, this is what I came up with. Is GDM always should be disabled? What about stress testing? I've…
I've had this card for about 4 months now and I've never bothered to overclock it until yesterday , felt like i was leaving performance on the table … Does anyone have experience with this card in general and what…
The following timings are at the lowest they can go: tWTRL, tWR, tRRDL, tRAS, tRC, tFAW (I think it's running at 48 because of other timings) and tRRDS
I can boot up 6400c26/2200 at 1.4vddio 1.24vsoc .95 vddp but for some reason, I can't stabilize it, I make it like 6 minutes into karhu sometimes and for the life of me dont want to waste more time on…
Well well well… I got myself a CH341A programmer with the 1.8v adapter as you guys recommended me, and got my 5070 fixed. I’ve definitely learned a lesson. Thank you guys for your help!!