I am currently running at 1.55V and 1.75V SoC. Also -25 Curve Optimiser. FLCK 1900 is stable, 2000 is not. Any suggestions I could use to make my RAM run better?
Pushing 7900XTX Memory to its Limit (Volt Modded)
So I have seen people manage to bench their 7900XT and XTX with Cinebench 2024 but for me the option is grev'd out and not sure whv. Iv tried a few driver versions released this year including the atest one…
First of all, I do not care one bit about why this problem came to be, who's to blame or people's arguments about why this issue exist in the first place because we are where we are and people need…
Good to see that it does improve the score at every memory clock increase and doesn't seem to be hitting that error correction
My SPD Hub Temp went up to over 71C after 1.5 hours of TM5 Absolut. I see that this is usually 10-15C LOWER than the actual DIMM temps, what do I do to fix this? I didn’t get any TM5…
Hey there, folks! I'm back again with the results from some RAM testing I did. This time, I'm comparing two stable settings (after hours of TestMem5 Absolute) on my Samsung B-die kit, and other "common" settings. (It's a 17-19-19 XMP,…
I had the PBO at +100 MHz and curve opt at -35. Then I activated LLC at level 2, and I got these temperatures in the Cinebench multi-core test. I've read somewhere that a poorly configured LLC can damage the…
Hi all, I posted my timings here, I’ve been working at this for a while now and mainly just want to know if TRAS should be put to 30. I currently have it set to 60 (TWR+TRTP) since I thought…
Lexar H24M 8000 kit to 6000 on AMDip
All is good, I already got a new connector on it. This was all my fault. I never let the card cool down. I seen 197 fps in steel nomad and kept chasing it with back back runs without giving…
Is my Ram speed good for DDR3 ?