I am planing to water cool my DDR5 RAM on the x870e Apex. Does anyone have this Kit from Barrow i found on Aliexpress? Which additional heatpads are necessary (0,5mm or 1mm?)? Is this a good Solution or are there…
I have zero knowledge in overclocking ram. The only thing I know about is making sure EXPO is turned on. From the short amount of research I have done, my setup should be around low 60s on latency. Anyone give…
I recently finished building my very first PC. I'm brand new to this hobby and completely new to overclocking, but I went down the rabbit hole of tuning my 9950X3D and the RTX 5080. Since this is my first time,…
I finally got a stable, fast overclock on my C-die ram. Here's the setup. Primaries wont really go tighter (go figure) but the subs were super nice with tRFC getting down to 317ns! Shout out to the countless threads I…
xpm профиль 36 36 36 96, комплект дефолтный, выше 6000мгц не берет даже на 1.540 вольтаже. на скрине единственное что получилось по таймингам стабильно. уперся в температуры и возможности материнской платы gigabyte z690 gaming x вероятно на z790 получилось бы…
Hello everyone, I'm trying to improve and optimize my memories. Where can I improve? The aim is to climb little by little, my will and try to ride above 8000mts. However, I found a good balance for now using 6400mts…
7900 XTX memory can overlock much better than once believed.
I have two Samsung memory modules and two other Hynix memory modules from different brands. (I know, it's not recommended; in fact, it should be 3600 for the Hynix modules).
I mean obviously it is higher than average at excellent rating, but on this sub everyone is sharing much higher scores, so I am wondering if it's any decent, or should I thinker more? This is stable OC preset and…
Pushing the ventus even further, now top 100 in the cpu / Gpu combo, 50 points left to get in SN
Spent couple nights going over different variations of Eclk but as its my 1st time experimenting i've more than likely done it wrong but this has worked so far, and what i ended up with is… 200Mhz boost Scaler x10…
Realistically is this the best i can expect from 4 dimms? If I touch tRDWR_sg and dg any lower i get boot fail