I've finally upgraded from the B650 Aorus Elite AX after two years and decided to get started on CL32 8000, since the limit on the Gigabyte B650 was only set to 1.650 VDD. Now, with this board so far, I've managed to reach 25K on Karhu, but this isn't fully validated for stability to my standard, since I normally go for 35K to 40K, but this is progress, nonetheless. I can't get CL30 8000 to work unfortunately, but this will suffice. I'm planning to get CL-26 6600 Stabilized, (If I can).
(Bios 7E59v2A91) Agesa 1.2.0.3g.
CPU: 7800X3D, PBO-Auto.
RAM: Corsair Vengeance CL30 DDR5 6400 1.40 (CMH32GX5M2B6400Z30) (Hynix A-Die).
SOC – 1.10V.
VDD – 1.68V.
VDDIO – 1.39V.
VDDQ – 1.55V.
VDDP – Auto (1.100mV).
VDDG – Auto (950mV).
All RTT values and resistances are set by the motherboard, but I don't understand why the RTT WR value is set to off. (I'll probably set it 40 ohms later.)
1/3/1 Nitro, Robust Training – Enabled.
DFE Read Training – Enabled.
IOMMU – Disabled.
Gear Down Mode – Enabled.
Bank Swap Mode – Swap APU.