Hi everyone,
I’m trying to overclock my GPU using MSI Afterburner, and I’m running into a frustrating issue.
- I set Core Clock +300 MHz and Memory Clock +1000 MHz.
- The voltage always stays at 870 mV, not just when I try to overclock—it never changes.
- Under FurMark, the GPU clock gets stuck around 1500–1800 MHz and won’t reach the values I set.
- Temperature is not the issue; the card isn’t throttling due to heat.
- I’ve tried increasing the curve in Afterburner (Shift + F) and manually adjusting voltage, but nothing changes.
I’ve seen videos where people can push both voltage and clocks much higher, but in my case, the voltage just won’t increase at all. I’m using a Gigabyte H610M-K motherboard, and my GPU is RTX 4060 model.
Has anyone experienced this behavior? Is it a BIOS limitation, or is there something else going on? Any advice would be appreciated!
Screenshoot1:https://prnt.sc/layEz227042a
Screenshoot2:https://prnt.sc/FyM-60MVANmk
edit:i changed nvdia control panel max performance to normal. it changed base when i didnt start but same 870 volt stucked again
without banchmark:https://prnt.sc/Om2NyD\_k72D6
with bachmark:https://prnt.sc/esEF7nincADA