9800X3D 6200C26 Fine tuned And Tested.

Here is my bench scores.

Aida64 (Safe mode)

Clam (Safe mode)

Pyprime 2B (Safe mode)

And Casual test with normal boot

All test that i did for check stability

Note : Currently im at 6200C26, i did these test with c28 but before that i did test with C26. So i know C26 works that mem vdd.

System Specs:

Asus Rog X870-A Motherboard

9800X3D

32X2 6400C32 A-data Xpg lancer

Msi Rtx 4080 Super

My only ZT screenshot

I did these setting on bios:

Tsme : Disabled

Sme : Disabled

Iommu: Disabled

Adress hashbank : Enabled

Bank Swap Mode [Swap APU]

Mcr Disabled

DDR training runtime reduction : Disabled

DDR5 Nitro Mode [Enable]

DDR5 Robust Training Mode [Enable]

Nitro RX Data [1]

Nitro TX Data [2]

Nitro Control Line [0]

Nitro Rx Burst Length [8X]

Nitro Tx Burst Length [8X]

I set the ARdPtrInitVal value to 0 for 34 34 tPHRDL's instead of 36 36.

Well my ram tuning jorney is over here. 6400 with DR so much harder to get stabilize. So i go with 6200C26.

Edit: some how my test screen shot was deleted. Here link that all validation tests on single boot : https://imgur.com/a/E6bA0wH