I’m on flush number three trying to undo the insanely stupid mistake I made, ha ha ha.
Positive-Olive3530
I’m going out on a limb and saying it was the flammable one
Ancient-Sweet9863
So alcohol and acrylic
RustBucket59
I just wanna know where you got your hands on 99.9% alcohol. I can’t find it anywhere locally.
wildman1024
90 percent distilled and 10 percent of the alcohol is about all you need.
McQuibbly
On the plus side, its easily cleaned with a lighter
vngannxx
ye3tr
Bruh imagine it boiling and melting trough
Arch3m
Oh no.
bl4derdee9
at least its sterile now….
Mithura
The correct one on the left.
A_PCMR_member
OH SHIT XD
Eziolambo
If propyl is stuck at some heat sensitive area, and you are unable to clean it, your system can explode ? Am I right or am I assuming the worst case scenario ? Nevertheless, clean every part after removing it from loop.
BigHairyNewfie
I was trying to upload the image of my similar mistake but reddit be reddit, I tipped a little on my gpu front plate and insert when I was cleaning the actual block and despite immediately rinsing it both spider cracked once they started to dry sorry for your misfortune op
ForgottenCaveRaider
How high were you?
Annual_Horror_1258
I came here to offer my condolences.
FunFact5000
Let’s get crunk
Visual-Ad9774
Which on actually did you use? i dont know anything about water cooling lol.
Harry_Flowers
Once I poured alcohol in a bowl of cereal cuz I was so dazed. Had to throw the whole bowl out, such a waste.
This, however, is considerably worse.
Exotic-Leading3608
Burn baby burn
A_I_L_L
How long was that Isopropanol in the cooling circle? How long did it run and did it get warm/hot? I would not have major concerns if it was not too long. There aint much pressure in such a system imho
21 Comments
https://preview.redd.it/u3uk6p1n085d1.jpeg?width=2268&format=pjpg&auto=webp&s=62ec6a060b9648600117cf497e9fe1ddb09461e5
I’m on flush number three trying to undo the insanely stupid mistake I made, ha ha ha.
I’m going out on a limb and saying it was the flammable one
So alcohol and acrylic
I just wanna know where you got your hands on 99.9% alcohol. I can’t find it anywhere locally.
90 percent distilled and 10 percent of the alcohol is about all you need.
On the plus side, its easily cleaned with a lighter
Bruh imagine it boiling and melting trough
Oh no.
at least its sterile now….
The correct one on the left.
OH SHIT XD
If propyl is stuck at some heat sensitive area, and you are unable to clean it, your system can explode ? Am I right or am I assuming the worst case scenario ? Nevertheless, clean every part after removing it from loop.
I was trying to upload the image of my similar mistake but reddit be reddit, I tipped a little on my gpu front plate and insert when I was cleaning the actual block and despite immediately rinsing it both spider cracked once they started to dry sorry for your misfortune op
How high were you?
I came here to offer my condolences.
Let’s get crunk
Which on actually did you use? i dont know anything about water cooling lol.
Once I poured alcohol in a bowl of cereal cuz I was so dazed. Had to throw the whole bowl out, such a waste.
This, however, is considerably worse.
Burn baby burn
How long was that Isopropanol in the cooling circle? How long did it run and did it get warm/hot? I would not have major concerns if it was not too long. There aint much pressure in such a system imho