Thinking about of this RAM cooling setup is sufficient enough or if I should create a custom loop just for the ram. Right now I'm running 6400 cl30 with tight timings 1.45v/1.38v vdd/vddq and with the both noctua fans set at 30% the left stick sits at 43 after 25 minutes tm5 ryzen3d.
Ambient 20°C.
I have a couple of questions:
- if everything stays the same but ambient is 40°C would the ram temp be at 63°C?
-Already replaced the orig heatsink with jeyi aluminum heatsink where proper thermalpads are included. Would the temps be lower if I would use copper heatsinks from icemen? If yes by how much degrees?
-would noise normalized a single nf-a8 chromax would do a better job then the two nf-a6x25?
-i know this is a stress test so the ram run the hottest. does ram run cooler in workloads which are heavy on ram? Probably a bit but not by much.