Reposting because I forgot the screenshots last time but I got a PowerColor 9070XT Hellhound yesterday and after doing an UV/OC I'm not convinced my numbers are correct. if you look at the last pic I have it set to 340W limit, +200 offset, 2800MHz VRAM, and a -75 voltage offset. I'm seeing almost 3500MHz and a 503W power draw as you can see in the OCCT screnshot. When I check the historical charts in LACT it only shows about 60 seconds worth of data but still showing 442W there. During Furmark it caps at 380W which is still way over what I should be seeing. I'm curious if there's a way to tell if it's the BIOS not limiting power correctly or if my sensors are way off. I'm on Linux so GPU-Z and 3DMark aren't options right now. I did a driver update today to see if that would change anything but all it did was give me higher clocks and less power. When I was checking last night power hit 512W and clocks topped out at 3488. I'll try to run some more FurMark passes in a bit but my room is 92F right now and I'm melting.