Hi all, I recently added an L shape to my desk for my racing sim and my mic does not reach it. Problem is it’s unidirectional and has to face one way, which makes just rotating it difficult. Any recommendations? Thanks!
Could you clamp it to the edge where your PC is? It might give you enough reach. A low profile mic arm is good for going under monitors, although they are shorter in length than the traditional counterparts.
Existing-Gas-4789
Looks like a stand would be best for this setup. Used to have the same monitor setup and had the same issue so I used a mic stand. An alternative for you would be to get a tall microphone stand that sits on the ground and place it behind your desk between the two monitors
Kuj000
A low-profile arm like the elgato one or the Auray (B&H in-house brand) could be placed in the inside corner of the L and would easily reach/pivot to both
3 Comments
Could you clamp it to the edge where your PC is? It might give you enough reach. A low profile mic arm is good for going under monitors, although they are shorter in length than the traditional counterparts.
Looks like a stand would be best for this setup. Used to have the same monitor setup and had the same issue so I used a mic stand. An alternative for you would be to get a tall microphone stand that sits on the ground and place it behind your desk between the two monitors
A low-profile arm like the elgato one or the Auray (B&H in-house brand) could be placed in the inside corner of the L and would easily reach/pivot to both