I'm looking for advice on how I can best configure my 2x16GB M-Die kit with the new FGR/mixed refresh modes offered by the new AGESA 1.3.0.0 BIOS update.
I did watch the buildzoid video and the impression I got was that it might be worth switching to mixed mode on H16M kits given they do lower tRFC2/tRFCsb.
I've been using the Pre AGESA 1.3.0.0 update on my board for the past month with what I assume is FGR since tRFC was being ignored in favour of tRFC2 and tRFCsb. The lowest
values I was able to successfully boot with at 6400 were 304 tRFC2 and 192 tRFCsb.
Much of the discourse I've seen about this online mostly revolves around H16A or H24M kits so I'm making this post seeking advice from anyone who's managed to test these settings on their M-die kit.